# Overview of Joint Properties

The **SWedge** analysis requires two (or three) distinct joint plane orientations to be defined. **SWedge** determines if a removable wedge can be formed by the intersection of the joint planes with the slope surface.

- If the Block Shape = Wedge then
**two**joint planes can be defined (Joint 1 and Joint 2) - If the Block Shape = Basal Joint then
**three**joint planes can be defined (Joint 1, Joint 2 and Basal Joint)

*Tetrahedral wedge formed by intersection of two joint planes*

To define the joint properties:

- Select
**Input Data**from the toolbar or the Analysis menu. - Select the appropriate tab(s) in the
**Input Data**dialog and enter the following joint properties: **Optional Joint Properties**- the following joint properties are optional, and can also be defined in the Input Data dialog:

**NOTE:** See the information below about the definition of Joint 1, Joint 2 and Basal Joint.

## Definition of Joint 1 and Joint 2

In **SWedge**the two primary joint planes defining a wedge are referred to as **Joint 1** and **Joint 2**. The **SWedge**analysis is formulated such that **either** joint plane can be defined as Joint 1 or Joint 2, this does not affect the solution. However, it is important to note that under the following circumstances, the Slope Height and the Tension Crack are measured with respect to **Joint 1**:

- If the slope face and upper face have different dip directions, this implies that the crest of the slope is not horizontal. In this case the slope height (wedge height) is measured with respect to Joint 1 (see dimension
**H1**in the following figure). - If the location of the Tension Crack is user-defined, then it is defined with respect to the trace length of Joint 1 from the crest (see dimension
**L**in the following figure).

If either of these situations applies to your **SWedge** model, then you will have to keep this in mind when you define the Slope Height or the Tension Crack location.

Arbitrary wedge formed by intersection of Joints (1 and 2) with Slope planes (3 and 4). Tension crack (5) is also shown. Slope height = H1. Joint 1 Trace Length (to define Tension Crack Location) = L.

## Definition of Basal Joint

If the **Basal Joint** option is enabled, **SWedge** allows you to define an additional (third) joint plane referred to as the basal joint, as illustrated in the figure below. This allows you to analyze five-sided (pentahedral) wedges formed by the intersection of 3 joint planes and the 2 slope planes. An optional tension crack can also be defined for basal joint wedges, in the same manner as described above for tetrahedral wedges.

See the Block Shape and Basal Joint topics for further information.

Wedge with basal joint