Expert Modelling: Hands-on help from Rocscience Engineers. Register Here

# Analysis Methods - SPT

## Triggering

A number of methods are available for liquefaction triggering. The most widely used approach consists of comparing the cyclic stresses with cyclic resistance of the soil (comparing CSR and CRR). Liquefaction is expected where induced stresses exceed the soil resistance.

The following methods are available for triggering of liquefaction:

• Seed et al. (1984)
• NCEER (1997)
• Boulanger and Idriss (2004)
• Cetin et al. (2004) Deterministic
• Japanese Bridge Code (1990)
• Cetin et al. (2004) Probabilistic
• Liao et al. (1998) Probabilistic
• Youd and Noble (2001) Probabilistic

## Settlement

Liquefaction settlement calculated in Settle3 is caused by the reconsolidation of the liquefied soil. Reconsolidation strains are calculated, based on the maximum shear strains that developed during the cyclic loading. The following methods are available for determining the volumetric strain.

• Ishihara and Yoshimine (1992)
• Tokimatsu and Seed (1987)
• Shamato et al. (1998)
• Wu et al. (2003)
• Cetin et al. (2009)

## Dry Sand Settlement

During dynamic shaking, it is well known that loose sands tend to compress and settle. During severe shaking this can cause liquefaction of saturated deposits. However, for dry sands liquefaction cannot occur since no water is present. For dry sands, dynamic shaking only causes the sand to compress and settle. The settlement addressing the seismic shaking is calculated in Settle3 using two different methods depending on the user input. If the user selects the Liquefaction method as Standard Penetration Test (SPT) then Settle3 will follow the SPT Dry Sand Settlement method by relating the volumetric strain to the cyclic shear strain and the earthquake magnitude (Pradel, 1998)

## Lateral Displacement

The lateral displacement is calculated based on the maximum shear strain. The following formulations are available in Settle3.

• Zhang Robertson and Brachman (2004)
• Tokimatsu and Seed (1987)
• Shamato et al. (1998)
• Wu et al. (2003)
• Cetin et al. (2009)

References for these documents can be found here.