|
|
 |
  |
|
    
|
|
Analysis Information
The Unwedge stability analysis is automatically computed
whenever input data is entered or edited. The current analysis results
are therefore always immediately available. Analysis results are presented
in a variety of ways and can be easily copied and pasted into other
applications for the writing of reports.
|
|
|
 |
|
Analysis Information: Wedge Information
Panel
A summary of wedge analysis information is always visible in the Sidebar
at the right of the screen. Results for each wedge are presented and
the display of information can be customized with the Wedge Information
Filter dialog. The information can be copied to the clipboard by right-clicking
in the panel and selecting Copy from the popup menu.
Wedge information panel in sidebar.
Wedge Information Filter dialog.
|
|
|
|
|
Analysis Information: Info
Viewer
The Info Viewer in Unwedge presents a complete summary
of all analysis data, including input parameters, wedge information
and support information. The Info Viewer information can be easily
copied and pasted into other applications for reports and presentations.
It can also be saved directly as a text file.
Info Viewer summary of analysis.
|
|
|
|
|
Analysis Information: Data Tips
Input data and analysis results are also available through interactive
Data Tips. Simply hover the mouse over entities on the screen and
the available information will be displayed in the form of a popup
data tip.
Wedge information (e.g. safety factor, wedge weight, volume, joint
areas etc) can be displayed by hovering the mouse over any wedge.
This is the same information which is also displayed in the sidebar
and can be customized using the Wedge Information Filter dialog.
Wedge Information data tip.
If the Joint Colours are displayed on the wedge planes, then the joint
properties (e.g. orientation, shear strength, water pressure) will
be displayed in the data tip when you hover the mouse over a wedge.
Joint Properties data tip.
Support information can be displayed by placing the mouse over any
support element (e.g. bolts, shotcrete or pressure).
Bolt Information data tip.
The Opening Section coordinates can be displayed by hovering the mouse
over any excavation vertex, while you are viewing the Opening Section
view.
Vertex coordinates data tip.
| |
|
|
|
Analysis Information: Measuring
Lengths and Angles
Lengths and angles can be easily measured anywhere on the model with
the “Length and Angles” measuring tool option. This allows
you to measure wedge dimensions, tunnel dimensions, support spacing,
orientations, etc., between any two points on the model.
For example, in the figure below, the length and orientation of one
edge of a wedge is being measured. The measuring tool consists of
a straight line between two cubes (handles), which highlight the ends
of the line. The handles of the measuring tool can be graphically
dragged to any point on the 3-dimensional model and will automatically
“snap” to vertices and line segments. The length and angle
information is displayed in the view.
Measuring wedge dimensions in the 3D perspective view.
|
|
|
|
|
 |
