Discharge Sections

A Discharge Section in Phase2 is a user-defined line segment or polyline, through which the steady state, volumetric flow rate, normal to the line segment(s), will be calculated during a groundwater seepage analysis.

• The value of the flow rate will be displayed in the Phase2 Interpret program, when you view the analysis results.

• Discharge Sections can only be defined in Phase2 if the Groundwater Method = Finite Element Analysis in Project Settings.

Discharge section (vertical green segment) defined for dam model

NOTE:

• Any number of discharge sections can be added to a model.

• A discharge section can be a single line segment or a polyline with multiple segments.

• If a discharge section is a polyline, Phase2 will calculate the flow through each segment of the polyline.

• A discharge section is independent of other Phase2 modeling entities. It does NOT get intersected with the model boundaries, and does NOT influence the finite element mesh.

Discharge Sections can be added, edited or deleted as described below.

Add Discharge Section

To add a Discharge Section:

1. Select Add Discharge Section from the toolbar or the Groundwater menu.

2. Enter the vertices of the discharge section. You can enter the points graphically with the mouse (the Snap option can be used to snap exactly to existing vertices), or you can enter the coordinates in the prompt line using the keyboard.

3. When all vertices are entered, right-click and select Done, or press Enter with nothing in the prompt line, and the Discharge Section will be added to the model.

The discharge section is displayed as a green line, with small circles marking the endpoints.

Delete Discharge Section

To delete a discharge section:

1. Select Delete Discharge Section from the toolbar or the Groundwater menu.

2. Use the mouse to select the discharge section(s) that you want to delete.

3. When you are finished selecting, right click the mouse and select Done Selection, or press Enter, and the selected section(s) will be deleted.

TIP: you can also use a right-click shortcut to delete a Discharge Section. Right-click directly on a Discharge Section and select Delete Discharge Section from the popup menu.

Edit Discharge Section

The vertices of a Discharge Section can be moved individually using the following right-click shortcut:

1. Right-click the mouse directly on a vertex of a Discharge Section.

2. Select Move To from the popup menu.

3. You can now move the vertex graphically with the mouse, or by entering coordinates in the prompt line.

NOTE: this option is not available in the menu or toolbar, only as a right-click option.